User`s manual

eBOX530-820-FL Series User’s Manual
Phoenix-Award BIOS Utility
33
z Quick Power On Self Test
This option speeds up Power on Self Test (POST) after you turn on
the system power. If set as Enabled, BIOS will shorten or skip some
check items during POST. The default setting is “Enabled”.
Enabled
Enable Quick POST
Disabled
Normal POST
z First/Second/Third Boot Device
These items allow the selection of the 1
st
, 2
nd
, and 3
rd
devices that
the system will search for during its boot-up sequence. The wide
range of selection is available.
z Boot Other Device
This item allows the user to enable/disable the boot device not
listed on the First/Second/Third boot devices option above. The
default setting is “Enabled”.
z Boot Up NumLock Status
Set the Num Lock status when the system is powered on. The
default value is “On”.
z Security Option
This item allows you to limit access to the system and Setup, or just
to Setup. The default value is “Setup”.
System
The system will not boot and access to Setup will be
denied if the incorrect password is entered at the prompt.
Setup
The system will boot, but access to Setup will be denied if
the correct password is not entered at the prompt.
NOTE To disable security, select PASSWORD SETTING
at Main Menu and then you will be asked to enter
password. Do not type anything, just press
<Enter> and it will disable security. Once the
security is disabled, the system will boot and you
can enter Setup freely.
z APIC Mode
Use this item to enable or disable APIC (Advanced Programmable
Interrupt Controller) mode that provides symmetric multi-processing
(SMP) for systems.