System information

Manual:System/UPS

Property Description

alarm-setting (delayed | immediate |

low-battery | none; Default: immediate)

UPS sound alarm setting:

• delayed - alarm is delayed to the on-battery event

• immediate - alarm immediately after the on-battery event

• low-battery - alarm only when the battery is low

• none - do not alarm

min-runtime (time; Default: 5m) Minimal run time remaining. After a 'utility' failure, the router will monitor the runtime-left value.

When the value reaches the min-runtime value, the router will go to hibernate mode.

•• 0 - the router will go to hibernate mode when the "battery low" signal is sent indicating that the

battery power is below 10%

offline-time (time; Default: 5m) How long to work on batteries. The router waits that amount of time and then goes into hibernate

mode until the UPS reports that the 'utility' power is back

•• 0 - the router will go into hibernate mode according the min-runtime setting and 10% of battery

power event. In this case, the router will wait until the UPS reports that the battery power is

below 10%

port (string; Default: ) Communication port of the router.

Read-only properties:

Property Description

load (percent) The UPS's output load as a percentage of full rated load in Watts. The typical accuracy of this

measurement is ±3% of the maximum of 105%

manufacture-date (string) UPS's date of manufacture in the format "mm/dd/yy" (month, day, year).

model (string) Less than 32 ASCII character string consisting of the UPS model name (the words on the front of the UPS

itself)

nominal-battery-voltage

(integer)

UPS's nominal battery voltage rating (this is not the UPS's actual battery voltage)

offline-after (time) When will the router go offline

serial (string) A string of at least 8 characters directly representing the UPS's serial number as set at the factory. Newer

SmartUPS models have 12-character serial numbers

version (string) UPS version, consists of three fields: SKU number, firmware revision, country code. The county code

may be one of the following:

•• I - 220/230/240 Vac

•• D - 115/120 Vac

•• A - 100 Vac

•• M - 208 Vac

•• J - 200 Vac

Note: In order to enable UPS monitor, the serial port should be available.

Example

To enable the UPS monitor for port serial1:

[admin@MikroTik] system ups> add port=serial1 disabled=no

[admin@MikroTik] system ups> print

Flags: X - disabled, I - invalid

0 name="ups" port=serial1 offline-time=5m min-runtime=5m

alarm-setting=immediate model="SMART-UPS 1000" version="60.11.I"