System information

Manual:Flashfig
117
RouterBOARD
• Flashfig mode is enabled on every RouterBOARD from factory by default, which means no configuration is
required on RouterBOARD.
•• If Flashfig is not enabled on your router, access the RouterBOARD with Winbox/Console and set the
configuration,
/system routerboard settings set boot-device=flash-boot
or use more preferable option,
/system routerboard settigs set boot-device=flash-boot-once-then-nand
Your router is now ready for Flashfig.
Connect
Connect RouterBOARD and Flashfig computer to the same Local Area Network.
Run Flashfig
•• Plug power for RouterBOARD
•• Check the status on Flashfig program,
Log shows "RouterBOARD Flashfigged" and RouterBOARD should make sound/LED signal, now it is safe to
unplug the router.
• Flashig configuration was applied to the RouterBOARD and it is ready to be used in production.