System information

Manual:Console
9
move cursor to the beginning of the line. If cursor is already at the beginning of the line, then go to the
beginning of the first line of current input.
Control-E or End
move cursor to the end of line. If cursor is already at the end of line, then move it to the end of the last line of
current input.
Control-L or F5
reset terminal and repaint screen.
up, down and split keys leave cursor at the end of line.
Built-in Help
The console has a built-in help, which can be accessed by typing ?. General rule is that help shows what you can
type in position where the ? was pressed (similarly to pressing [Tab] key twice, but in verbose form and with
explanations).
Safe Mode
It is sometimes possible to change router configuration in a way that will make the router inaccessible (except from
local console). Usually this is done by accident, but there is no way to undo last change when connection to router is
already cut. Safe mode can be used to minimize such risk.
Safe mode is entered by pressing [CTRL]+[X]. To save changes and quit safe mode, press [CTRL]+[X] again. To
exit without saving the made changes, hit [CTRL]+[D]
[admin@MikroTik] ip route>[CTRL]+[X]
[Safe Mode taken]
[admin@MikroTik] ip route<SAFE>