System information

Manual:Flashfig
113
Manual:Flashfig
Applies to RouterOS: v4
Description
Flashfig is an application for mass router configuration. It can be used by MikroTik distributors, ISPs or any other
companies who need to apply RouterOS configuration to many routers in shortest possible time.
Flashfig applies MikroTik RouterOS configuration to any RouterBOARD within 3 seconds. You can "flashfig"
batch of routers, the only thing you need - connect RouterBOARD to network and power it.
Flashfig runs on a Windows computer, Flashfig is available within Netinstall
[1]
.
Flashfig is supported by all RouterBOARDs
[2]
. It works between computer with Flashfig and RouterBOARD in the
same broadcast domain (direct Ethernet network connection is required).
Flashfig support is enabled on every new RouterBOARD by default from factory (RouterBOARDs manufactured
after March 2010). For older models, Flashfig can be enabled via RouterBOOT or from MikroTik RouterOS console.
After Flashfig is used once on a brand new RouterBOARD, it is disabled to avoid unwanted reconfiguation at later
time. To use Flashfig a second time on the same router, you need to enable it in Bootloader settings.
If RouterOS reset-configuration command is used later, Flashfig configuration is not loaded, but RouterOS default
configuration.
Flashfig diagram shows the procedure of Flashfig,