System information

Manual:Troubleshooting tools

Note: If you use UDP protocol then Bandwidth Test counts IP header+UDP header+UDP data. In case if you

use TCP then Bandwidth Test counts only TCP data (TCP header and IP header are not included).

Configuration example:

Server

To enable bandwidth-test server with client authentication:

[admin@MikroTik] /tool bandwidth-server> set enabled=yes authenticate=yes

[admin@MikroTik] /tool bandwidth-server> print

enabled: yes

authenticate: yes

allocate-udp-ports-from: 2000

max-sessions: 100

[admin@MikroTik] /tool bandwidth-server>

Client

Run UDP bandwidth test in both directions, user name and password depends on remote Bandwidth Server. In this

case user name is ‘admin’ without any password.

[admin@MikroTik] > tool bandwidth-test protocol=udp user=admin password="" direction=both \

address=10.0.1.5

status: running

duration: 22s

tx-current: 97.0Mbps

tx-10-second-average: 97.1Mbps

tx-total-average: 75.2Mbps

rx-current: 91.7Mbps

rx-10-second-average: 91.8Mbps

rx-total-average: 72.4Mbps

lost-packets: 294

random-data: no

direction: both

tx-size: 1500

rx-size: 1500

-- [Q quit|D dump|C-z pause]

More information and all commands description can be found in the manual>>