User's Manual

-9-
11. Plug in the keyed battery connector to the main circuit board.
12. Replace the top of the gateway enclosure with its gasket and reattach it with the bolts.
13. Attach the Gateway Antenna to the Gateway.
There may be times when access to the inside of the Gateway is desired to disconnect the
battery, observe the LEDs, or access debug functions. At these times, remove the top of the
enclosure and its bolts. Replace the gateway enclosure top when done.
Once set up, the Gateway should attempt to establish a mesh. It will continue to broadcast and
look for new nodes indefinitely.
Mesh Master – Small form factor computer
To assemble the Mesh Master server collect a keyboard (not included), a mouse (not included), a
monitor (not included), an Ethernet cross over cable, the Mesh Master host computer, and the
Mesh Master computer power adapter. Then follow these steps:
1. Connect the keyboard, mouse and monitor to the Mesh Master computer.
2. Connect the power adapter to the Mesh Master computer.
3. Connect the Ethernet cross over cable to the Mesh Master computer and the PoE adapter
(LAN port).
4. Plug in the Mesh Master computer power adapter.
5. Press the ‘power’ button on the front of the Mesh Master computer.
6. Observe that the system boots.
7. To place the Mesh Master server on a local network, connect an Ethernet cable to the first
Ethernet port (white Ethernet cable in the picture).
The database used by Mesh Master is installed as a service on the machine so it will start
automatically. There are two additional pieces of Mesh Master which are started manually.