User's Manual

-8-
7. One Crossover Ethernet cable (orange)
8. Five MeshStamps
9. Five MeshStamp Antennas
10. Five Mesh Stamp battery cases
11. AA Batteries
12. One Mesh Master host computer
13. One Mesh Network Eval Kit Contents Sheet
Ethernet Gateway
The Ethernet Gateway comes assembled in its enclosure. To set up the Ethernet Gateway follow
these steps:
1. Remove the Gateway from its box.
2. Remove the bolts, which fasten the top of the enclosure.
3. Remove the top of the enclosure.
4. Plug the Ethernet cable into the Power over Ethernet Adapter (in the PoE port).
5. Plug the Ethernet cable into the Ethernet connector on the side of the gateway enclosure.
6. Connect the PoE adapter to the PoE power supply (DC port).
7. Plug in the PoE power supply.
8. Observe that the Power LED illuminates.
9. Observe that the Gateway module becomes active. (Rcv LED is on, Mesh Status LED is
blinking)
10. Observer that the Ethernet Power LED Illuminates.