User's Manual

-10-
First is the collector, which manages communications to the Gateway, captures any data
collections from the network and stores them in the database. The collector is started by double
clicking its shortcut on the desktop.
Second is the Mesh Master GUI interface. The GUI interface is started by double clicking on its
shortcut on the desktop.
If this Evaluation Kit being installed has been powered up before, the Mesh Master database may
have retained some old data. To start fresh, follow the procedure in 0 Clearing old Alarms, Data
Samples to clear this data.
MeshStamps®
To assemble a MeshStamp® collect 3 alkaline AA batteries, one battery pack, one MeshStamp®
antenna and one MeshStamp®. Then follow these steps for each of the MeshStamps®:
1. Insert the 3 batteries into the battery pack. Be sure to follow the instruction on battery
direction.
2. Connect the antenna to the Mesh Stamp.
Note: the supplied antenna is the only antenna authorized for
use with the MeshStamp®.
TX LED
Rcv LED
Mesh LED
Packet
LED