User's Guide

PE_QW1_V04_US
12
1.10 User identification number
1.11 Control number
The indication of irrelevant parameters can be turned off. Also, parameters that are not relevant to the
set meter configuration will not be indicated.
The indication of parameters can be turned on or off by means of the configuration programme „W1
TOOL“ through the optical interface when installing the meter (if the meter is in the transport mode).
Viewing the readings in verification (test) mode
Menu structure in verification (test) mode is presented in the Fig 6.2.
Fig. 6.2. Menu structure in verification (test) mode
Volume readings in verification mode
Parameter Value (example) Remark
High-resolution integrated
volume
Updated every 10 second.
Flow-rate value and
inscription „tESt“ are
changes every second
Info (Status) codes
Operating Status are encoded by a 4-digit code:
Code number Description
nXXX
0 - Normal operation
1 - Reconfiguration warning
2 - No consumption
4 - Damage of meter housing
8 - Calculator's hardware failure detected
XnXX
0 - Normal operation
1 - Leakage
2 - Pipe is cracked (Burst)
4 - Optical communication temporarily stopped
GAL
GPM
GAL