User manual

TPOS PRINTER SERIES Set-up Guide
Page 6 / 12
Reference: FDE-3107243 Issue A
2.3.4 USB connector
The connector is located at the rear of the printer, and is of B-type. The maximum recommended cable
length is 3 meters. Refer to USB specification rev 1.1, chapter 6, for more information.
USB PARAMETERS
Axiohm’s implementation of USB complies with “Universal Serial Bus Specification” revision 1.1.
2.3.4.1 Capabilities:
TPOS is only a device, and doesn’t provide hub capabilities. Full speed communications (12Mbits/sec) are
supported.
2.3.4.2 Connector:
The connector is located at the rear of the printer, and is of B-type Refer to USB specification rev 1.1
chapter 6 for more information.
2.3.4.3 Interface:
The data is exchanged between host and printer via four endpoints:
1) Endpoint 0x00: CONTROL
Default endpoint
2) Endpoint 0x02: BULK OUT
For transmission of all printable data and commands from host to printer
3) Endpoint 0x82: BULK IN
For return of all synchronous data, status or other types of information except unsolicited status mode
messages, from printer to host
4) Endpoint 0x01: INTERRUPT OUT
For transmission of real time commands from host to printer.
2.3.4.4 Other information:
Vendor Id Product Id
Axiohm USB Vendor Id = 0x05D9 TPOS Product Id = 0xA000
2.4 General safety specification
All communication connectors should be SELV connectors in order to meet safety standards.
Use of an inappropriate cable or power supply may seriously damage your printer and affect safety
standards of the printer. The power supply main connector should be accessed to enable power
disconnection.
The power supply cable is a disconnect device.
Power supply input requirements: 110/240 VAC, 50/60 Hz.
Operating temperature: 0 to 50°C.