Specifications

26 Series 150 Operator’s Guide
LOADING AND REMOVING PAPER
This section describes how to load and remove paper. Change the paper
when the ALARM light turns red. This indicates that the paper is low. The
printer will stop. You must change the paper for the printer to resume
operation.
INSTALL THE NEW PAPER ROLL
Follow these instructions for loading either single- or multiple-ply paper.
Note: If this is a new installation, a receipt roll is supplied with the
printer. If you are changing multiple-ply paper, remove the
journal take-up roll before loading the new roll. See
“Remove the Journal Take-up Roll” on page 34.
Installing Paper without the Knife Option
If your printer has the optional knife installed, refer to “Installing Paper with
the Knife Option” on page 30 for paper loading instructions.
1. Open the paper cover.
If you are changing the paper, remove the used supply roll. Do not pull
on the paper to remove unused paper from the printer. Instead, push the
FEED button. This removes unused paper from the printer safely.
2. Tear off a clean edge on the new roll, and fold the paper straight.
This makes it easier to load the paper.