Specifications

ASTRIUM Set-Up Guide 7/14 Reference :3108332 - Issue Z
n Using a screwdriver, remove extractable parts (D) so that you can then route the cables externally
according to your needs. Ensure that the passage slots are completely clear of any plastic protrusion that
could damage the cables.
WARNING: Once removed, the extractable parts cannot be reattached.
D
D
D
D
D
n Refit the connectors cover by inserting the covers lower and upper tabs into the corresponding slots
(E) and (F), routing the cables through the passage slots that were opened in the previous step.
F
E
E
VIEW BEHIND THE CONNECTORS COVER
Power supply jack
Drawer interface
Open
connectors
cover
Mutually exclusive
interface (available on slot
pluggable interface card):
- Bi-directional parallel
- Serial (25-pin)
- USB
- Serial (9-pin)
Display interface
available with the
following interfaces:
Serial (9-pin) and USB
n Make sure that the printer and all the devices connected to it are powered off and then insert the free
end of the power cord into the electrical power outlet.
n Power on the printer as explained in the section Powering On the Printer.
n Load the paper roll as explained in the section Loading the Thermal Paper Roll.
PDF created with pdfFactory trial version www.pdffactory.com