Specifications

ASTRIUM Set-Up Guide 14/14 Reference :3108332 - Issue Z
GENERAL INFORMATION
Safety precautions and general operating norms
Read this section carefully before using this product.
n Make sure that the electrical characteristics of the printer’s external power supply unit (110/240 Vac,
50-60 Hz) correspond to those of the electrical socket to which it is connected.
n Connect the printer to an electrical system compliant with the latest standards.
n Do not locate the printer in direct sunlight, near water, near heat sources or in humid or very dusty
environments.
n In case of smoke, bad odors or unusual noise coming from the printer, unplug the external power
supply and contact the field engineering service.
n Do not locate the printer in direct sunlight, near water, near heat sources or in humid or very dusty
environments.
n To avoid the risk of injury, do not touch the parts indicated in the following figures :
Printhead: very hot
Cutter blade:
very sharp
Manual cutter
blade:
very sharp
Cutter counter
blade:
very sharp
n Do not pull the receipt paper from its output slot when the printer cover is closed.
n Do not open the printer cover during a print job or when the incorporated cutter is cutting the receipt
paper.
n Do not attempt to repair the printer except for following the troubleshooting procedures; contact the
field engineering service.
n Do not disassemble or modify the printer.
n Do not insert foreign objects into the printer.
n Unplug the printer’s external power supply unit from the electrical wall outlet if the printer is left
unattended for long periods of time.
n If the printer is not used for long periods of time, it is suggested that you open its cover by pressing the
cover open button as far as it goes. This prevents feeble areas from appearing on initial printouts taken as
soon as the printer is back into use.
PDF created with pdfFactory trial version www.pdffactory.com