Specifications

ASTRIUM Set-Up Guide 10/14 Reference :3108332 - Issue Z
Adjusting the almost out of paper sensor
NOTE: THE ALMOST OUT OF PAPER DETECTION SENSOR IS ADJUSTED AT THE FACTORY TO
BE FUNCTIONALLY COMPATIBLE WITH THE MOST WIDESPREAD PAPER ROLLS.
If the printer signals an almost out of paper condition when there is either still too much or not enough paper
still present in the paper roll compartment, you can proceed to adjust sensor detection accordingly.
The adjustment of this sensor depends upon the diameter of the core of the paper roll used. When moving the
adjustment lever towards the rear of the machine less paper will be present when the almost out of paper
condition is signaled while when moving the lever towards the front of the machine more paper will be
present.
Proceed as follows to adjust the almost out of paper sensor:
n Open the printer cover by pressing the Open button on the operating console as far as it goes (until
hearing a click sound indicating that the button is locked in a pressed position).
n Move the green adjustment lever (A) towards the front of the printer if you wish to have a more
anticipated indication (in the case of cores with a larger diameter), or towards the rear of the printer if you
wish to have a more delayed indication (in the case of cores with a smaller diameter).
n Load the roll of thermal paper.
A
PDF created with pdfFactory trial version www.pdffactory.com