User manual

APOS KANJI User Manual Page 29 / 45
Ref : 3103039-FDE Issue A
4.1.26. ESC m
(Description) Perform partial cut
(Format) <1Bh> <6Dh> <n>
(Comments) The command is valid only when a cutter is fitted.
(Cross reference) ESC i
4.1.27. AX C
(Description) Select cut position
(Format) <1Fh> <43h> <n>
(Comments) If n = 0, cut command will cut under last printed line.
If n = 1, cut command will cut over last printed line.
0 <= n <= 1
Default value is n = 1
(Cross reference) ESC i, ESC m
4.1.28. GS w
(Description) Set horizontal magnification of bar code
(Format) <1Dh> <77h> <n>
(Comments) n defines how many 1/6mm units are used to print the thin line of each
barcode symbology. The thick lines will be set to twice the value of n.
2 <= n <= 4
Default value is n = 3
(Cross reference) GS h, GS k
4.1.29. GS h
(Description) Select vertical height of bar code
(Format) <1Dh> <68h> <n>
(Comments) The vertical height will be set to n 1/8 mm units.
1 <= n <= 255
Default value is n = 162
(Cross reference) GS k, GS w