User manual

APOS Premium Printer Series User Manual Page 8 /136 Reference: FDE 3107312 Issue A
2.4 Operational performance
2.4.1 Paper specification
Paper width
80mm
Maximum paper roll diameter
83mm
(Maximum paper roll length)
82m (using 60gsm paper)
Recommended papers
AXIOHM ref 3101123
KANZAKI P350
Emulsion (sensitive) side
On outside of roll
* You must contact Axiohm if you wish to use an alternative type of paper; otherwise your warranty might
not be valid and you could cause damage to your printer.
2.4.2 Speed
The printer is capable of printing at a maximum speed of 130mm/s with 20% of the dots on, provided that
sufficient power supply current is available (See section 2.1.3 about power supply requirements).
The actual speed can also be affected by the data rate at which information is sent to the printer over the
communication link. Sending large amounts of graphic data could reduce the actual speed.
2.4.3 Lifetime
The printer lifetime depends on the actual operating conditions and is defined by the MTBF of the
electronics and the wear characteristics of the electromechanical parts. The actual lifetime will therefore be
the minimum of the following three categories, depending on the particular application:
• Electronic MTBF of 220,000 hrs of powered use
• 100km of paper used by the printer (with typically 20% of the dots heated)
• Two million cuts from the ceramic cutter mechanism.