User manual

APOS Premium Printer Series User Manual Page 30 /136 Reference: FDE 3107312 Issue A
4.6.2 USB PARAMETERS
Axiohm’s implementation of USB complies with “Universal Serial Bus Specification” rev 1.1
4.6.2.1 Capabilities
Apos Premium is a device only, and doesn’t provide hub capabilities.
Full speed communication (12Mbits/sec) is supported.
4.6.2.2 Connector
The connector is located at the rear of the printer, and is specified as B-type
Refer to USB specification rev 1.1 chapter 6 for more information.
4.6.2.3 Interface
The datas are exchanged between host and printer via five endpoints:
Endpoint 0x00 : CONTROL
Default endpoint
Endpoint 0x02 : BULK OUT
For transmission of all printable datas and commands except real time commands, from host to printer
Endpoint 0x83 : BULK IN
For return of all synchronous datas , status or other types of information except unsolicited status mode
messages, from printer to host
Endpoint 0x81 : INTERRUPT IN
For return of asynchronous datas, typically unsolicited status mode messages, from printer to host
Endpoint 0x04 : INTERRUPT OUT
For transmission of real time commands, from host to printer.
4.6.2.4 Other information
- USB V1.1
- Full Speed communication 12 Mbits/sec
- Single USB Connector (Peripheral mode)
Vendor ID: Product Id:
Axiohm USB Vendor Id = 0x05D9 APOS PREMIUM product Id = 0xA000