User manual

APOS Premium Printer Series User Manual Page 127 /136 Reference: FDE 3107312 Issue A
S
ET KNIFE OPTION
Synopsis:
Set Knife Option
Syntax:
ASCII:
US ETX STX
n
Decimal:
31 3 2
n
Hex:
1F 03 02
n
Operand:
n = mode selection
Limit:
Decimal:
0 ≤ n ≤ 1
Hex:
00 ≤ n ≤ 01
Description: This command will store the knife option in non-volatile memory.
Note:
KNIFE OPTION OPERAND DEFINITION
Decimal Hex Mode
0 00 Disabled
1 01 Enabled
S
ET PARTIAL CUT DISTANCE
Synopsis:
Set Partial Cut distance parameter
Syntax:
ASCII:
US ETX LF
n
Decimal:
31 3 10
n
Hex:
1F 03 0A
n
Operand:
n = width selection
Limit:
Decimal:
0 ≤ n ≤ 4
Hex:
00 ≤ n ≤ 04
Description: This command will store the partial cut distance parameter in non-volatile memory.
Note: This setting must be set to match the mechanism connected to the board, in order to get partial cut
position matching the knife notch.
This setting is used to compensate for mechanical tolerances on parts involved in knife operation.
PARTIAL CUT DISTANCE OPERAND DEFINITION
Decimal Hex Mode
0 00 125 knife motor steps
1 01 130 knife motor steps
2 02 135 knife motor steps
3 03 140 knife motor steps
4 04 145 knife motor steps