User manual

APOS Premium Printer Series User Manual Page 126 /136 Reference: FDE 3107312 Issue A
S
ET PRINT DENSITY
Synopsis:
Setting Print density
Syntax:
ASCII:
US VT
N R
J
n
Decimal:
31 11
83 80
69
n
Hex:
1F 0B 4E 52 4A
n
Limit:
Decimal:
70 ≤ n ≤ 120
Hex:
46 ≤ n ≤ 78
Description: Set the print density ( energy applied to paper ) in percent relative to nominal energy.
WARNINGS!!
Choose a print density setting no higher than necessary to achieve acceptable print density
Failure to observe this rule may result in a printer service call
Failure to observe this rule may void the printer warranty
Consult your Axiohm technical support specialist if you have questions
S
ET PREHEATING OPTION
Synopsis:
Set Print head pre-heating mode
Syntax:
ASCII:
US ETX VT
n
Decimal:
31 3 11
n
Hex:
1F 03 0B
n
Operand:
n = mode selection
Limit:
Decimal:
0 ≤ n ≤ 1
Hex:
00 ≤ n ≤ 01
Description: This command will store the print head pre-heating option in non-volatile memory.
Note: When this mode is enabled, the controller monitors the print head temperature and keeps it above
35°C
PRE-HEATING OPTION OPERAND
DEFINITION
N
Decimal Hex Mode
0 00 Disabled
1 01 Enabled