User manual

APOS Premium Printer Series User Manual Page 105 /136 Reference: FDE 3107312 Issue A

ET ABSOLUTE VERTICAL PRINT POSITION IN PAGE MODE

Sets the absolute vertical print starting position for buffer character data in page mode.

The absolute print position is set to [(nL + nH X 256) x (vertical or horizontal motion unit)] inches.

The vertical or horizontal motion unit for the paper roll is used and the horizontal starting buffer position

does not move.

The reference starting position is set by the Select Print Direction in Page Mode (ESC T), and operates

setting the absolute position in the vertical direction, when the starting position is set to the upper left or

lower right; and sets the absolute position in the horizontal, when the starting position is set to the upper

rights or lower left.

The horizontal and vertical motion units are specified by the Set Horizontal and Vertical Minimum Motion

Units (GS P) command.

The Set Horizontal and Vertical Minimum Motion Units (GS P) command can be used to change the

horizontal and vertical motion unit.

However, the value cannot be less than the minimum horizontal movement amount, and it must be in even

units of the minimum horizontal movement amount.

ASCII

GS $ nL nH

Hexadecimal 1D 24 nL nH

Decimal

29 36 nL nH

Formulas

[(nL + nH X 256) x (vertical or horizontal motion unit)] inches.

Exceptions

This command is effective only in page mode.

If the [(nL + nH X 256) x (vertical or horizontal motion unit)] exceeds the specified printing area, this

command is ignored.