User manual

APOS Premium Printer Series User Manual Page 102 /136 Reference: FDE 3107312 Issue A

ELECT STANDARD MODE

Switches from page mode to standard mode. In switching from page mode to standard mode, data buffered

in page mode are cleared, the printing area set by Set Print Area in Page Mode (ESC W) is initialized and

the print position is set to the beginning of the line.

This command switches the settings for the following commands (the values for these commands can be set

independently in standard mode and page mode) to those for standard mode:

Set Right-Side Character Spacing (ESC SP)

Select 1/6 Inch Line Spacing (ESC 2)

Set Line Spacing (ESC 3)

Standard mode is automatically selected when power is turned on, the printer is reset, or the Initialize

Printer command (ESC @) is used.

ASCII

ESC S

Hexadecimal 1B 53

Decimal

27 83

Exceptions

This command is effective only in page mode.

ELECT PRINT DIRECTION IN PAGE MODE

Selects the printing direction and start position in page mode. See the illustration.

The command can be sent multiple times so that several different print areas, aligned in different print

directions, can be developed in the printer’s page buffer before being printed using the Print Page Mode

commands (FF or ESC FF).

ASCII

ESC T n

Hexadecimal 1B 54 n

Decimal

27 84 n

Value of n Start position

0 = Upper left corner proceeding across page to the right (A)

1 = Lower left corner proceeding up the page (B)

2 = Lower right corner proceeding across page to the left

(upside down) (C)

3 = Upper right corner proceeding down page (D)