Instruction manual

A794 Owner’s Guide Chapter 6: Programming Information
December 1999 91
Select Superscript or Subscript Modes
ASCII AX ENQ n
Hexadecimal 1F 05 n
Decimal 31 05 n
Value of n: 0 = Normal character size
1 = Select subscript size
2 = Select superscript size
Default: 0 (normal size)
Turns superscript or subscript modes on or off. This attribute may be combined with
other characters size settings commands (12, 13, 1B 21 n, 1D 21 n,…)
Exceptions
This command is ignored if n is out of the specified range.
Related Information
In A7193 Emulation, this command is unrecognized and the parameter byte is put into
the print buffer.
Summary of Rotated Printing
The table shows the combinations of Set/Cancel Upside Down Print, Set/Cancel
Rotated Print (clockwise), and Rotated Print (counterclockwise).
Rotated clockwise and Rotated counterclockwise print commands are mutually
exclusive: The setting of the last received command is effective . Unintended
consequences may result when Rotated clockwise is mixed with other commands.
The samples of the print show only the normal size characters. Double-wide and
double-high characters are printed in the same orientation. They may also be mixed on
the same line.
Upside Down
(1B 7B
n
)
Rotated CW
(1B 56
n
)
Rotated CCW
(1B 12)
Resulting Output
Canceled Canceled Cleared
ABC
Canceled Set X
C
B
A
Set Canceled X
ABC
Set Set X
C
B
A
XXSet
A
B
C
Note: The following print modes cannot be mixed on the same line:
♦ Standard and compressed pitch
♦ Vertical (normal) and rotated
♦ Right-side up and upside down
♦ Single high (normal) and double high