Instruction manual

A794 Owner’s Guide Chapter 6: Programming Information
December 1999 87
Select or Cancel Italic Print
ASCII ESC I n
Hexadecimal 1B 49 n
Decimal 27 73 n
Value of n: 0 = Off
1 = On
(When 0 and 1 are the Least Significant Bit, LSB)
Default: 0 (Off)
Turns Italic Print Mode on or off. The printer is reset to the standard Print Mode after a
Clear Printer (0x10) command is received.
Exceptions
Only the lowest bit of n is valid.
Related Information
This command is recognized only in A794 Native Mode.
In A973 and TM-T88 Emulations, the parameter byte is put into the buffer.
Select International Character Set and Select Character Code Table
ASCII:ESC R n ESC t n
Hexadecimal: 1B 52 n 1B 74 n
Decimal: 27 82 n 27 116 n
A794 Native Mode A793 Emulation TM-T88 Emulation
(1B 52 n only)
Value of n:
0 = Code Page 437 0 = Code Page 437 0 = U.S.A.
1 = Code Page 850 Not 0 = Code Page 850 1 = France
2 = Code Page 852 2 = Germany
3 = Code Page 860 3 =-U.K.
4 = Code Page 863 4 = Denmark I
5 = Code Page 865 5 = Sweden
6 = Code Page 858 6 = Italy
7 = Code Page 866 7 = Spain
8 = Code Page 1252 8 = Japan
9 = Norway
10 = Denmark II
Default: 0 (Code Page 437)
Selects the character set to be used. See Print Specifications for the character sets.
There are two codes for this command. Both codes perform the same function.
Related Information
The TM-T88 Emulation selection applies only to the command “Select International
Character Set” (1B 52 n). The TM-T88 Emulation generates the same as A794 Native
Mode for the command “Select Character Code Table” (1B 74 n).