Instruction manual

Chapter 6: Programming Information A794 Owner’s Guide
December 199996
Print Advanced Raster Graghics
ASCII ESC . m n rL rH d1 … dn
Hexadecimal 1B 2E m n rL rH d1 … dn
Decimal 27 46 m n rL rH d1 … dn
Value of m: horizontal offset from left margin = 8 x m dots
Value of n: number of data bytes that compose the raster
Value of r: number of times the raster has to be printed =256 x rH + rL
d1 … dn: data bytes
Range: 0<= m <= 72
0<= n <= 72
0<= r <= 65535
0<= d1 … dn <= 255
Prints a horizontal raster of graphics data one or multiple times. Horizontal offset and
number of data bytes are variable and specified by parameters.
Exceptions
Advanced Raster graphics is not available in Page Mode
Select Single-Density Graphics
ASCII ESC K n1 n2 d1 ... dn
Hexadecimal 1B 4B n1 n2 d1 ... dn
Decimal 27 75 n1 n2 d1 ... dn
Value of n
Value of
n
(8-Dot
Single Density Mode)
Value of
n
(24-Dot Single
Density Mode) Value of
d
n1 + (256 x n2) 3 x [n1 + (256 x n2)] Number of Bytes of Data
(Printed Down, Then Across)
Enters one line of 8-dot single-density graphics into the print buffer. Any print
command is required to print the line, after which the printer returns to normal
processing mode. Single-density mode allows 0-288 dot columns. The number of bytes
sent is represented by the formulas in the table.
Each bit corresponds to two horizontal dots. Compare to Set Bit Image Mode (1B 2A,
m=0) earlier in this document.
Formulas
See the above table.
Related Information
In TM-T88 Emulation, this command is unrecognized and the parameters are put into
the print buffer.