Setup guide

9
Customize the 10K120 Interface
The 10K120 interface is customized with special PLU items. The items are
entered into the 2127 using a PLU maintenance file.
There are two sets of maintenance files, one set for those 2127 systems set up for
20 character PLU descriptors and one set for those 2127 systems set up for 12 to
19 character PLU descriptors. Use only the set that matches your systems PLU
descriptor length. The procedure to install either set is the same.
The 2127 Add and Delete maintenance files along with the 10K120 interface PLU
Configuration scan tags are available online at www.wrenchman.com/products.
These PLU item UPC numbers were reserved by Wrenchman, Inc. from the
Uniform Code Council and will never appear on any item in a store.
• If not already received on floppy disks, copy and unzip the add and delete
PLU maintenance files onto separate PC formatted diskettes.
Add Procedure
• Place the add disk into the drive on the 2127 register and turn the keylock to
the "Super" position.
• Enter your Supervisor Number followed by the Enter key.
• At the Enter Action Code prompt enter 65
• Enter file number 1 and press the Enter key.
• Enter selection code 1 and press the Enter key twice.
• At the Enter Action Code prompt enter 56.
• Enter file number 1 and press the Enter key.
• Enter device 1 followed by the Enter key.
• Press the Enter key again.
The disk drive should go active and load the file into the 2127.
• Enter 60 when prompted for an action code.
• Enter a 1 for the file number and press the Enter key.
• Enter a 1 for the selection code followed by the Enter key.