Setup guide

7
• Reset the 2127 register by pressing the "1" key twice.
The display will show a line of "D"s with indicators.
Changing Machine Definition Code Values
• Log out all cashiers.
• Turn the keylock to the "Prog" position.
• Enter your Secret Number when prompted, followed by the P2 key.
• At the Enter Program Number prompt, enter 1 and press the P1 key.
• Enter 89 when prompted for the Report or Address of the Machine
Definition Code, followed by the P2 key.
Changing the value for address 89 permits zero price PLU’s
required for configuring the 10K120 interface. Restore this setting
to the original value after the 10K120 interface is configured by
following the procedure in this section.
• Enter the value for the corresponding displayed address, given in the
table below, followed by the P1 key.
The address is automatically incremented.
• Press the P2 key several times to increment the address to 103.
Follow the procedure in the step above to set the values for the
addresses in the table below.
• After entering the new value for the addresses below, press the P1 key
to finalize.
The 2127 will return to the Enter Program Number prompt.
The Machine Definition Codes and Values
Machine Definition
Code (Address) Value
89 xx1x
103 0000
104 0xx0
105 1000
106 xxx0
x = the value’s digit remains the same, as shown on the
display for the corresponding address.
17
The P3 key is directly to the left of the “7” key on the numeric keypad.