Setup guide

Optional MICR connection

• Connect the Wrenchman 10K96 MICR cable DB9-M connector to the

DB9-F connector on the 10K120 “Y” or dual cable assembly.

• Connect the other end of the 10K96 cable, a JAE dual row 14 position

connector, to the mating connector on the 2127 register that the Welch

Allyn MICR reader was using.

If MICR was not in use, connect the 10K96 cable to either mating

14 position connector on the 2127 register’s OCRS 1 board.

See the attached photographs for illustrations of the proper connections to the

10K120 interface and the 2127 register.

Setup the 2127 register to support the 10K120 interface

Several of the 2127 configuration parameters and Machine Definition Codes must be set

to specific values for the 10K120 interface to operate properly.

The user should possess an understanding of the procedures to configure the 2127

The 2127 manuals, "Action Code Entries", "Parameter Entry", and "Machine Definition

Codes" provide information to set 2127 register configuration parameters and describes

their function.

All numeric values are entered with the number keys for the steps below.

Set the 2127 register to use a multifunction printer.

• Place the keylock in the “Super” position and hold down the P1 key

during power-up of the 2127 register.

• Type 2127 when prompted for the Access Number and press the Enter

key.

• Type 3 to access Menu Data

• Type 2 to access the Peripheral Menu

• Scroll to menu items by pressing the P1 key.

• Set printer 1 to a "YES" and printers 2 and 3 to "NO"

using the P2 key

• Press the P3 key

to exit the Peripheral Menu.

The 10K96 cable will mate with only one of the connectors on the assembly.

The P1 key is the bottom key in the column of keys to the right of the numeric keypad.

The P2 key is the bottom key in the column of keys to the left of the numeric keypad.