Setup guide

5
10K120 Interface Connections
The 10K120 interface consists of electronics enclosed in a small plastic case with
two cable assemblies.
NCR 2127 register connection
• The connector
11
on the 10K120 interface single cable assembly plugs into a
mating connector on NCR 2127. Connect to any of the six available mating
sockets on the back panel of the register.
See the attached 2127 Register Back View picture.
Axiohm printer connection
• Screw the DB9-M connector on the 10K120 “Y” or dual cable assembly to the
mating DB9-F connector on the supplied Axiohm printer cable.
12
• Securely attach the DB9-F connector on the free end of the Axiohm cable to
the printer’s communications connector. See Axiohm’s printer “Setup or
Owner’s Guide”.
If the Axiohm cable is not available, a cable wired as below will work.
13
Cable
10K120 interface to Axiohm printer
DB-9 Receptacle DB-9 Receptacle
(female) (female)
Pin No. Pin No.
1 & 6 4
2 2
3 3
4 1 & 6
5 5
7 7
8 8
9 N.C. N.C. 9
Shell Shell
N.C. = No Connection
11
A Compu-shield, Series 31, 15 position plug is on the 10K120 interface single cable assembly.
12
Only one of the connectors, a DB9-M on this cable assembly will mate with the Axiohm cable.
Axiohm cable P/N: 4970008562
13
This is the typical pin-out of a standard “null modem” cable sold at computer stores.