Setup guide

10
• Press the Enter key again.
The 2127 should indicate MMM communications and the printer
should print a message showing "27 applied 0 failed".
Create Department 100
If “Dept Not Found” or a related message appeared when the last step above was
performed or when the configuration labels are entered in the next section, then
Department 100 will have to be temporarily created. Follow the next steps to do
this:
• At the Enter Action Code prompt, enter 113.
• Enter 100 when prompted for the Department Number
• Press the Enter key twice to finalize the setting.
A report should print indicating that a department was created.
Delete Procedure
The procedure to delete these PLU items from the 2127 follows the same
procedure except the delete floppy is used instead of the add floppy.
MICR Feature Option
If the MICR feature is to be used, information about the MICR user exit
configuration will need to be known before setting the 10K120 interface options.
• At the Enter Action Code prompt, enter 260.
• Scroll to address 14 by pressing the P1 key.
• Note the value of the first digit in the four digit number shown.
If the first digit is 0, use the “Format Dumac Short” tag for the 10K120
configuration.
If the first digit is 1, use the “Format Dumac Long” tag for the 10K120
configuration.
• Press the P2 key to exit Action Code 260
• Turn the keylock back to the “Reg” position and log in a cashier allowing
transaction items to be entered.