Instruction manual

A758 Owner’s Guide Chapter 5: Techical Spcifications
September 1999 66
Slip Media
The A758 prints 1 to 5 part forms with the following limitations:
♦
The minimum thickness of a single part form is .08 mm (.003 inch).
♦
If present in a multi-part form, cardstock will be the bottom part.
♦
Maximum total thickness is .40 mm (.016 inch).
♦
Minimum form reflectivity is 60%
Minimum form length (feed direction) for forms inserted from the front up to the
slip stop is 68 mm (2.68 inches) w/o check flip option and 70 mm (2.75 inches)
w/Flip option. Minimum form width (print direction) is 51 mm (2.00 inches).
These minimums ensure the form covers both optical slip detectors, and expose
about one inch of the form to push in place.
The form must be at least 127 mm (5.00 inches) wide to print all 66 standard or 80
compressed columns. Large forms may be inserted from the left side and
override the slip stop. Forms over 170 mm (6.70 inches) wide will extended
outside the left side of the printer.
Receipt Media
♦
Direct thermal paper, with or without environmental coating.
♦
Paper thickness range: 51–86 µm (2.0–3.4 mil).
♦
Receipt roll width: 80 + .2 - .6 mm (3.150 + .008 - .024 inch).
♦
Receipt roll diameter: 90 mm (3.54 inch) maximum.
♦
Receipt roll capacity: * 98M (322 feet) of 61µm (2.4 mil) thick paper
73.5M (241 feet) of 81µm (3.2 mil) thick paper
♦
Roll construction: Image side facing out.
♦
End-of-roll warning: Stripe recommended, not required.
* Based on core diameter of: 22 ± .5 mm (.87 inch) outside,
11.5 ± .5 mm (.45 inch) inside.