Instruction manual

A758 Owner’s Guide Chapter 5: Techical Spcifications
September 1999 59
Slip Side
Guide
Paper Holes and
Low Reflection
Prohibited Areas
Slip
Edge
19 mm
(0.747 in.)
8 mm
(0.315 in.)
6 mm
(0.236 in.)
Slip/LED
Sensor
MICR
Head
Slip
Sensor
Paper Feed
Direction
B
A
The Slip/LED Sensors use a reflective photo sensor.
♦
Do not use paper that has holes or is translucent at the Slip/LED Sensor
location. (See “A” in above illustration.)
♦
Do not use paper that has holes on dark areas with low reflection (less than
60% reflection) at the Slip Sensor location. (See “B” in above illustration.)
♦
Thin paper should be used between the top and bottom sheets of multi-ply
paper. Thick paper reduces the copy capability.
MICR Reader – Additional Information
♦
The check must be flat and void of curls, folds, or wrinkles (especially at the
edges). Wrinkled checks may rub against the ribbon causing them to become
ink-stained.
♦
Checks must be void of clips or staples. Paper jams, MICR read errors,
and/or MICR head damage could occur.
♦
Immediately release the check once the printer starts to feed it. Failure to
release the check could skew it, causing paper jams and MICR read errors.