Instruction manual

A758 Owner’s Guide Chapter 3: Using the Printer
September 1999 42
On-Line, Paper Status, Error LED Flashes
Problem/Symptom Possible Causes What to Do
On Line, Paper Status, Error LED
is blinking.
Receipt paper is out. Change
the paper now. Do not run a
transaction without paper as
the data may be lost.
Change the paper immediately. See
“Loading and Changing the Receipt
Paper” in the
Owner’s Guide
.
Receipt, front or flip cover is
open.
Close the cover. The printer will not
operate with any of the covers open.
The knife is jammed. Open the receipt cover and check
the knife. Clear any jammed paper
you can see. Tear off any excess
paper against the tear-off blade.
The slip is jammed. Open the Front Cover and clear
paper from path.
The carriage is jammed. Open Front Cover and clear paper
from path.
A jam during flip. If visible through Front Window,
open access door and clear paper
jam, if not, open Front Cover and
clear jam.
Receipt paper is low.
There are about 4.5 meters,
±
3
meters, (15 feet,
±
10 feet) of paper
left. Change the paper soon to avoid
running out of paper part way
through a transaction. See “Loading
and Changing the Receipt Paper” in
this document.
AC supply voltage is out of
range.
Continued…
If paper is not low and no
conditions indicate that the thermal
printhead is too hot, then it is likely
that the power supply voltage is out
of range. Contact a service
representative.