Instruction manual

A758 Owner’s Guide Chapter 3: Using the Printer
September 1999 38
Knife Option
This function makes it possible to set the Knife Option if it is installed in the
printer. This setting should only be changed if the option is added or removed.
Paper Low Sensor
Paper Low Sensor setting makes it possible to enable or disable the paper low
sensor for particular printer configurations.
Printhead Resistance
The printhead in the thermal receipt printer can be one of two types. The
printhead resistance setting must match the character (A or B) stamped on the
heatsink in the back of the printhead. This character is visible by removing the
top cover of the printer. Only a trained service representative may remove this
cover. Therefore, under normal use this setting should be left at the factory
default.
The printhead resistance settings are set by using the Configuration Menu. See
“Configuring the Printer” for instructions on how to enter the Configuration
Menu.
MICR Option
This function makes it possible to set the MICR Option if it is installed in the
printer. This setting should only be changed if the option is added or removed.
Check Flip Option
This function makes it possible to set the Check Flip Option if it is installed in the
printer. This setting should only be changed if the option is added or removed.