Instruction manual

A758 Owner’s Guide Chapter 3: Using the Printer
September 1999 37
Emulation/Software Options
Printer Emulations
Printer emulations determine the commands that are available to the printer.
They are set by using the Configuration Menu. (See “Configuring the Printer” for
instructions on how to enter the Configuration Menu.) The available options are:
A758 Native (enables all new functions)
A756 Emulation (for use with legacy software)
Printer ID Mode
This switch is used to determine what Printer ID value is returned in response to
a Transmit Printer ID (1D 49 01) when the printer is in A756 Emulation Mode.
The printer can be configured to send back the ID of the A758 or the A756.
Default Lines Per Inch
This function allows the user to set the default lines per inch printed by the
thermal receipt printer to 6, 7.52 or 8.13. (See “Configuring the Printer” for
instructions on how to enter the Configuration Menu to change this setting.)
Carriage Return Usage
This function allows the printer to ignore or use the Carriage Return
(hexadecimal 0D) command depending on the application. Some applications
expect the command to be ignored while others use the command as a print
command. (See “Configuring the Printer” for instructions on how to enter the
Configuration Menu to change this setting.)
Hardware Options
Print Density
This function makes it possible to adjust the energy level of the printhead to
darken the printout. An adjustment should only be made when necessary. The
factory setting is 100%.
Warning:
Choose an energy level no higher than necessary to achieve a dark
printout.
Failure to observe this rule may result in a printer service call or voiding of the
printer warranty. Consult your Axiohm technical support specialist if you have
any questions.
Maximum Power
This function makes it possible to match the printer to the wattage of the power
supply. The 55 W power supply is standard, whereas the 75 W power supply
enables the printer to optimize speed at higher dot coverage. (See “Configuring
the Printer” for instructions on how to enter the Configuration Menu to change
this setting.)