Instruction manual

A758 Owner’s Guide Chapter 3: Using the Printer
September 1999 36
Check Flip Test Mode
To run the Check Flip Test Mode:
1. Enable the Check Flip Test Mode through the Configuration Menu (See
“Configuring the Printer,” for instructions on how to enter the Configuration
Menu), then exit the Configuration Menu.
2. Insert a check as if validating the check, lengthwise and face down into the
slip station. (See “Verifying and Validating Checks” section to insert check.)
A check must be used—if any other slip or form is inserted the printer will
not conduct the test.
Extended
Slip Table
Slip
Table
Check
Guide
Green
Slip-in LED
First Line of
Print Guide
Check Orientation - Face down
ENDORSE HERE
MEMO
3. Push Paper Feed Button.
The check then goes through the flip routine only—no printing takes place.
To exit the Check Flip Test Mode:
1. Enter the Configuration Menu again.
2. Disable the Check Flip Test Mode.
3. Exit the Configuration Menu.
The printer is in Normal Mode and can communicate with the host
computer.