Manualshelf

Instruction manual

ManualsBrandsAxiohm ManualsComputer equipmentA758
31323334353637383940
A758 Owner’s Guide Chapter 3: Using the Printer
September 1999 34
2.
After you have enabled the Datascope Mode through the Configuration
Menu, exit the Configuration Menu.
3.
Run a transaction from the host computer.
All commands and data sent from the host computer will be printed as
hexadecimal numbers as shown in the illustration.
To exit the Datascope Mode:
1. Enter the Configuration Menu again.
2.
Disable the Datascope Mode.
3.
Exit the Configuration Menu.
The printer is in Normal Mode and can communicate with the host
computer.
Receipt Test Mode
To run the Receipt Test Mode:
1.
Enable the Receipt Test Mode through the Configuration Menu. See
“Configuring the Printer,” for instructions on how to enter the Configuration
Menu.
2.
Push Paper Feed Button and the receipt station will print two code pages.
3.
The test ends with a cut.
4.
Go to step 2 again to repeat this test.
To exit the Receipt Test Mode:
1.
Enter the Configuration Menu again.
2.
Disable the Receipt Test Mode.
3.
Exit the Configuration Menu.
The printer is in Normal Mode and can communicate with the host
computer.
Slip Test Mode
To run the Slip Test Mode:
1.
Enable the Slip Test Mode through the Configuration Menu, (See
“Configuring the Printer,” for instructions on how to enter the Configuration
Menu). Then exit the Configuration Menu.
2.
Insert a slip into the slip station.