Instruction manual

A758 Owner’s Guide Chapter 3: Using the Printer
September 1999 20
Changing the Receipt Paper
Change the paper when either a colored stripe appears on the receipt paper or
the printer’s On Line, Paper Status, Error LED slowly flashes (indicating that
15 + 10 feet of paper remains on the roll). Change the paper as soon as possible to
avoid running out of paper part way through a transaction.
If the On Line, Paper Status, Error LED blinks fast, the paper is out. Change the
paper immediately or data may be lost. The printer will not operate without
paper, but it may continue to accept data into memory from the host computer.
Because the printer cannot print any transactions, this data in memory may be
lost.
Receipt
Cover
To change the receipt paper:
1. Open the cover and remove the used roll.
2. Tear off the end of the new roll so that the edge is loose.
3. Place the roll into the paper bucket with the paper unrolling from the bottom
of the roll, and with a few inches of paper extending over the cabinet front.
Paper must unroll from the bottom of the roll to insure the image will print.
4. Close the cover while holding the paper over the front of the cabinet.
5. Remove the excess paper by tearing it against the tear-off blade.
6. Advance the paper if necessary by pressing the Paper Feed Button.