Instruction manual

A758 Owner’s Guide Chapter 2: Setup Guide
September 1999 16
Testing the Printer
The Configuration Menu allows you to set general printer parameters. The test
prints a list of various printer settings and partially cuts the paper if a knife is
installed. The test printouts may vary depending on the printer model. To change
the default settings, enter the Configuration Menu as instructed on the bottom of
the test printout. The printout may be useful to a service representative if there is
a problem. If something appears to be wrong with the test printout (such as
missing or faded text) additional troubleshooting and diagnostic guides are
available by calling 1-[phone].
1. To run the test, either:
a. Open and close the receipt cover while holding down the Paper Feed
Button,
OR,
b. Press the Paper Feed Button and the Reset Button at the same time.
2. When the printer begins printing let go of the Paper Feed Button.