Instruction manual

A758 Owner’s Guide Chapter 7: Programming Guide
September 1999 200
Flash Allocation
ASCII
: GS " U
n1 n
Hexadecimal
: 1D 22 55
n1 n2
Decimal:
29 34 85
n1 n2
Default Value of
n1
:
1 (see below)
Default Value of
n2
:
1 (see below)
n1 is the number of 64k sectors used for logos and user-defined characters.
n2 is the number of 64k sectors used for user data storage.
This command sets the allocation of Flash sectors between user data storage and
logos/user-defined characters. This allocation is saved in the EEPROM of the
printer and is therefore saved across power cycles.
n1 + n2 <= 2 (512K)
n1 + n2 <= 10 (1M)
n1 + n2 <= 18 (2M)
The A758 has been configured at the factory with 512K, 1M or 2M of Flash
memory. If n1 + n2 is greater than the maximum number of sectors available, the
command is ignored. Reissuing this command with different parameters will
erase all sectors.
Exception:
This is command is available only in A758 Native Mode