Instruction manual

A758 Owner’s Guide Chapter 7: Programming Guide
September 1999 180
Print Data in Page Mode
ASCII
:ESC FF
Hexadecimal
:1B 0C
Decimal:
27 12
Collectively prints all buffered data in the printing area.
After printing, the printer does not clear the buffered data and sets values for
Select Print Direction in Page Mode (1B 54 n) and Set Print Area in Page Mode
(1B 57…), and sets the position for buffering character data.
Exceptions:
This command enabled only in Page Mode.
Select Page Mode
ASCII
:ESC L
Hexadecimal
:1B 4C
Decimal:
27 76
Switches from Standard Mode to Page Mode. After printing has been completed
either by the Print and Return to Standard Mode (FF) command or Select
Standard Mode (1B 53) the printer returns to Standard Mode. The developed
data is deleted after being printed.
This command sets the position where data is buffered to the position specified
by Select Print Direction in Page Mode (1B 54) within the printing area defined
by Set Print Area in Page Mode (1B 57).
This command switches the settings for the following commands (which values
can be set independently in Standard Mode and Page Mode) to those for Page
Mode.
♦
Set Right-Side Character Spacing (1B 20)
♦
Select 1/6-Inch Line Spacing (1B 32)
♦
Set Line Spacing (1B 33)
It is possible only to set values for the following commands in Page Mode. These
commands are not executed.
♦
Select or Cancel 90 Degree Clockwise Rotation (1B 56)
♦
Select Justification (1B 61)
♦
Select or Cancel Upside-Down Printing (1B 7B).
♦
Set Left Margin (1D 4C)
♦
Set Print Area Width (1D 57)
Exceptions:
The command is enabled only when input at the beginning of a line.
The command is available only when the receipt is selected by Select Paper
(1B 63 30).
The command has no effect if Page Mode has previously been selected.
The Select Paper (1B 63 30) command can not be used in Page Mode.
In A756 Emulation Mode, (1B 4C…) is used for double density graphics.