Instruction manual

A758 Owner’s Guide Chapter 2: Setup Guide
September 1999 12
Connecting the Cables
Caution:
Connect the cables to the printer before plugging in the power supply.
If power is received from the host computer, turn it off before connecting any
cables.
Back of
Printer
Strain Relief
DIP
Switches
Communication
Connector
(9-pin connector
shown)
Power
Supply
Connector
Cash
Drawer
Connector
Note:
Depending on your printer configuration, the connector panel may vary
from the above illustration.
Communication Cable
The communication cable connects the printer to the host computer. To install the
communication cable:
1. Turn off the host computer.
2. Secure the communication cable to its connector under the printer in the
location previously shown.
3. Connect the cable to the host computer.