Instruction manual

A758 Owner’s Guide Chapter 7: Programming Guide
September 1999 145
Select Superscript or Subscript Modes
ASCII:
AX ENQ
n
Hexadecimal:
1F 05
n
Decimal:
31 05
n
Value of
n
:
0 = Normal character size
1 = Select subscript size
2 = Select superscript size
Default:
0 (normal size)
Turns superscript or subscript modes on or off. This attribute may be combined
with other characters size settings commands ( 12, 13, 1B 21
n
, 1D 21
n
, …)
This command is only available on the receipt station in A758 Native Mode.
Exceptions:
This command is ignored if
n
is out of the specified range.
This is only available in A758 Native Mode.
Summary of Rotated Printing
The table shows the combinations of Set/Cancel Upside-Down Print, Set/Cancel
Rotated Print (clockwise), and Rotated Print (counterclockwise). Rotated CCW is
mutually exclusive with the other two commands. Unintended consequences
may result when rotated CCW is mixed with other commands.
The samples of the print show only the normal size characters. Double-wide and
double-high characters are printed in the same orientation (double-high
characters cannot be printed on the slip station). They may also be mixed on the
same line.
Upside Down
(1B 7B
n)
Rotated CW
(1B 56
n)
Rotated CCW
(1B 12)
Resulting Output
Canceled Canceled Cleared
ABC
Canceled Set X
C
B
A
Set Canceled X
ABC
Set Set X
C
B
A
XXSet
A
B
C
Note:
The following print modes cannot be mixed on the same line:
♦
Standard and compressed pitch
♦
Vertical (normal) and rotated
♦
Right-side up and upside down
♦
Single high (normal) and double high