Instruction manual

A758 Owner’s Guide Chapter 7: Programming Guide
September 1999 116
Select Receipt or Slip for Setting Line Spacing
ASCII
: ESC c 1
n
Hexadecimal
: 1B 63 31
n
Decimal:
27 99 49
n
Value of
n:
1, 2, 3 Select receipt
4 Select Slip
Default of
n
:
1
Selects which station receives the effects of the following commands:
Select Default Line Spacing (1B 32)
Set Line Spacing (1B 33)
Add
n
extra dot rows (16
n
)
Exceptions:
This command is ignored if
n
is out of range.
Select Paper Sensors to Output Paper End Signals (Parallel Only)
ASCII
: ESC c 3
n
Hexadecimal
: 1B 63 33
n
Decimal:
27 99 51
n
Value of
n
:
If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper
sensor outputting paper-end signals.
If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper
sensor outputting paper-end signals.
Bit Position Hex Decimal Function
0Off
On
00
01
0
1
Paper roll near end sensor disabled
Paper roll near end sensor enable
1Off
On
00
02
0
2
Paper roll near end sensor disabled
Paper roll near end sensor enabled
2Off
On
00
04
0
4
Paper roll end sensor disabled
Paper roll end sensor enabled
3Off
On
00
08
0
8
Paper roll end sensor disable
Paper roll end sensor enabled
4, 5,
6, 7
- - - Undefined
Range of
n
: 1 - 255
Default:
15
Specifies the paper sensor to output a paper end signal. Multiple sensors may be
selected to signal when paper has run out. When multiple sensors have been
selected, anytime one of the sensors detects a paper end, the paper end signal is
output.
When this command is executed a sensor is switched. The paper end signal
switching is delayed depending on the receive buffer state.