User manual
A630/A631/A632 Printer Series User Manual Page 57 / 63 Reference: FDE 3106894 Issue F
5.3.11.1.3 PRINT
DENSITY
Synopsis: Setting Print density
Syntax: ASCII:
US VT N R J n
Hex: 1F 0B 4E 52 4A
n
Limit: Decimal:
70 ≤ n ≤ 150
Hex:
46 ≤ n ≤ 96
Description: Set the print density (energy applied to paper) in percent relative to nominal energy.
WARNINGS!!
Choose a print density setting no higher than necessary to achieve acceptable print density
Failure to observe this rule may result in a printer service call
Failure to observe this rule may void the printer warranty
Consult your AXIOHM technical support specialist if you have questions
5.3.11.1.4 RESET
EEPROM
Synopsis: Reset EEPROM
Syntax: ASCII:
US CR C L E n
Hex: 1F 0D 43 4C 45
n
Operand:
n = security byte
Limit:
n = 0
Description: This command will reset the non-volatile memory configuration items to their default
values.
Notes
:
• This command must be sent while the printer is in its normal operating mode.
• Once the configuration parameters are downloaded to the printer using this command, the printer
must be reset before they take effect.
• Disabling the knife is not an option when a presenter is selected.
RESET EEPROM
OPERAND DEFINITION
n
Decimal Hex Reset
0 00 Reset EEPROM