User manual

A630/A631/A632 Printer Series User Manual Page 21 / 63 Reference: FDE 3106894 Issue F
3.3 Loading paper
The Clamshell
TM
design allows easy paper loading.
To load paper:
Refer to the illustrations while following these steps:
 Open the cover using finger recesses.
 Set the paper roll as indicated on the picture below
by pushing aside the right roll support.
 Close the cover leaving a small length of paper out.
 Cut the small length left with the tear bar. Your
paper roll is set.
Note :
The paper used should be recommended by AXIOHM
The paper width must be 58 mm
The maximum paper roll diameter is 50 mm
Warning :
1) Close the cover by pushing the two sides
simultaneously.
2) It is possible to load the paper when the printer
is powered (On). In this case, check if it is still
powered (On) after closing the cover; if not, press
the On/Off button.
Roll setting
indications
right roll support