Specifications

7193 Service Guide Chapter 5: Disassembling and Reassembling the Printer
August 1998 47
Replacing the Knife Assembly
1. Place the left knife support over the left side of the knife blade.
2. Slide the rotating blade into the right-hand knife support.
3. Replace the two screws in the left-hand knife support, securing it to the frame.
4. Place the slotted drive arm on the right end of the rotating blade.
5. Replace the set screw in the top of the slotted drive arm by using a 1½ mm hex driver.
6. Reattach the ground strap from the printhead to the right side of the rotating blade.