Specifications
7193 Service Guide Chapter 3: Diagnostics
August 1998 27
Setting the 7150 Response Mode
This function allows you to set the 7193 to respond as an NCR 7150™ printer for the
Configuration Message at the link level and the Request Status command at the command
level. This “7150 response mode” allows the 7193 to communicate with those LCSIO (RS-
485) host computers whose drivers recognize the NCR 7150™ but not the 7193.
Caution: The DIP switches are pre-set at the factory and should generally not be changed.
If you must change them, do so carefully to avoid changing other functions. Run the print
test to see the current settings for this function. See “Testing The Printer” in chapter 2.
1.
Turn the power off.
2.
Turn the printer over and note what the current DIP switch settings are.
3.
Set the switches to the settings in the table that match selection you want for the 7150
Response Mode (on or off).
Switch 1 Switch 2 Switch 3 Switch 4 Switch 5 Switch 6 7150 Response Mode
On Off On Off Off Off Off (Default)
On Off On Off Off On On
4.
Turn the power back on to enter the settings into the EEROM.
On remote models, the On Line light (green) blinks.
5.
Turn the power off.
6.
Set the DIP switches to the former settings.
DIP switch 1 must be Off to return the printer to the on-line mode.