Specifications

Chapter 3: Diagnostics 7193 Service Guide
August 199826
Setting Partial Cut Distance
This function allows you to change the length of the partial knife cut. The higher the
number, the longer the cut.
Caution: The DIP switches are pre-set at the factory and should generally not be changed.
If you must change them, do so carefully to avoid changing other functions. Run the print
test to see the current settings for this function. See “Testing The Printer” in chapter 2.
1. Turn the power off.
2. Turn the printer over and note what the current DIP switch settings are.
3. Set the switches to the settings in the table that match the cut distance value you want
(the higher the number, the longer the cut ).
Switch 1 Switch 2 Switch 3 Switch 4 Switch 5 Switch 6 Cut Distance Value
On On Off Off Off Off 0
On On Off Off Off On 1
On On Off Off On Off 2
On On Off Off On On 3
On On Off On Off Off 4
On On Off On Off On 5 (Default)
On On Off On On Off 6
On On Off On On On 7
4. Turn the power back on to enter the settings into the EEROM.
On remote models, the On Line light (green) blinks.
5. Turn the power off.
6. Set the DIP switches to the former settings.
DIP switch 1 must be Off to return the printer to the on-line mode.