Specifications

7193 Service Guide Chapter 3: Diagnostics
August 1998 25
Setting Default Lines per Inch
This function allows you to set the default for lines per inch to either 7.6 or 6.
Caution: The DIP switches are pre-set at the factory and should generally not be changed.
If you must change them, do so carefully to avoid changing other functions. Run the print
test to see the current settings for this function. See “Testing The Printer” in chapter 2.
1. Turn the power off.
2. Turn the printer over and note what the current DIP switch settings are.
3. Set the switches to the settings in the table that match the lines per inch setting you
want as the default setting (when the printer is powered up).
Switch 1 Switch 2 Switch 3 Switch 4 Switch 5 Switch 6 Default LInes per Inch
On Off On On On Off 7.6 (Factory Setting)
OnOffOnOnOnOn6.0
4. Turn the power back on to enter the settings into the EEROM.
On remote models, the On Line light (green) blinks.
5. Turn the power off.
6. Set the DIP switches to the former settings.
DIP switch 1 must be Off to return the printer to the on-line mode.